Houston water is hard on water heaters. The City’s 2025 water quality report puts average hardness for the main system at about 135 mg/L, roughly 8 grains per gallon, which the U.S. Geological Survey calls “hard.” It varies by area and water source. Those minerals settle in the bottom of the tank as sediment. If you’re in a water district (MUD) outside the city, your district publishes its own report.
No hot water (gas)
Usually it’s a pilot that won’t stay lit, a bad thermocouple or flame sensor, or a gas valve problem. On newer gas models, a clogged air-intake screen (garage lint and dust) can shut it down too.
No hot water (electric)
Check the breaker first. If it’s fine, it’s usually a tripped high-limit switch or a failed heating element. Both sit behind a cover with live 240-volt wiring, so leave them to us.
Hot water runs out fast
Sediment taking up room in the tank, a failed lower element on an electric heater, or a tank that’s simply too small for the household. We’ll tell you which.
Water around the base: tank or fitting?
Where the water comes from matters. A leaking drain valve, relief valve or fitting on top is usually a repair. Water coming from the tank itself means the tank is done, and it’s time to replace it.
Water coming out of the pipe on the side
That’s the temperature and pressure relief valve, a safety device. Never cap or plug it. Either the valve is worn, the tank is getting too hot, or the pressure is building up as the water heats. That last one is thermal expansion, common in homes with a pressure-reducing valve or backflow device and no working expansion tank. All of these need a plumber.
Popping or rumbling
That’s sediment on the bottom of the tank. A flush may quiet it down. If the noise keeps up after a flush, the tank is aging.
Rusty or brown hot water
Run the cold tap first. If only the hot water is rusty, the tank’s anode rod may be used up, or the tank is starting to rust inside. If the cold water is rusty too, the problem is in the pipes or the water supply.
Rotten-egg smell in the hot water
Usually bacteria in the water reacting with the tank’s magnesium anode rod. Flushing the tank and switching to a different, manufacturer-approved anode rod usually fixes it. A gas smell near the heater is different: leave the house and call 911 and CenterPoint.
Tankless water heater acting up
Error codes, hot-and-cold showers or a unit that shuts off mid-shower? See our tankless water heater page.
Pilot won’t stay lit
A bad thermocouple or flame sensor, a dirty pilot, a draft, or a clogged air-intake screen. Don’t keep relighting it. Let us find out why it’s going out.
Here is what builds up inside a tank: sediment and mineral buildup around the anode rod. Watch on YouTube
Sources: City of Houston 2025 water quality report · USGS water hardness